JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Home
Frequently Asked Questions
Can you please advise on the correct speed for cutting half dovetails with the CJ300. In fact, do I need to use different speeds depending on the type of joint being made. Thank you.

Frequently Asked Questions

Can you please advise on the correct speed for cutting half dovetails with the CJ300. In fact, do I need to use different speeds depending on the type of joint being made. Thank you.

The cutter speed is usually linked to the cutter diameter the smaller the diameter the faster the speed so as the dovetail cutters are reletively small we would recomend the upper level of speed reduce to stop any burning.

Created by Richard Green

Was this article helpful ?